Tuesday, March 8, 2016

Finally Underway



Day 11: Thursday, March 3, 2016

This guy was moored on the opposite side of our dock
I awoke early this morning and spent a couple of hours getting caught up on my blog postings.  Janine came around at about 6:00 and we prepared a bacon, eggs and toast breakfast.  Of course, the first thing that I do when I get up is to light the fire under the coffee pot.

We tossed off the dock lines at about 8:30 and started motoring down the Big Marco River on our way to the open waters of the Gulf.  For the first few miles the congestion of Marco Island was obvious and then suddenly we were deep in the mangrove islands.  I was involved in a discussion,
Second Wind resting with the Damn Dink Too at Rose Marina
several days ago, about how easy it is get disoriented and lost amongst these islands.  But, we have good charts, a good GPS chart plotter, and the channels are well documented so that there is really no concern about getting lost as long as you follow the channel markers.

It is a beautiful area and aptly named the Ten Thousand Islands.  We didn’t see an abundance of wild life although we did see a few egrets, and a number of ospreys.  The ospreys are noisy rascals.  They build
Our other neighbor. A boat for old tired sailors
their massive nests on the channel markers and the squawk loudly in a high pitch whistle as you pass.  We saw a number of occupied nests but no young.

We motored for probably 3 hours through the narrow passages.  The wind was light but on our nose so there was no way to sail.  We finally broke out into Gullivan Bay which is an indentation off of the Gulf of Mexico.  Our course swung southeast and with a light westerly breeze, we were able to sail.  The fastest that we saw on our GPS was about 2.5 knots or about 3 mph.  Most of the time we were traveling along at around 2 knots.  But
Stan's in Goodland FL from the water.
, we are in no hurry and so we sailed for probably 4 hours.  We had selected a fairly nice spot to drop our anchor but it was obvious that at the speed we were traveling, we would not reach our goal.
The sky was lightly to moderately overcast most of the day and by evening it was cloudy.  With the cool breeze, we both wore long sleeve sweaters

We readjusted, started the motor and headed behind an island called Lumber Key.  We arrived at about
Heading down Big Marco River near Goodland FL
4:30, dropped anchor, buttoned up the boat and sat down for hors d'oeuvres that included a nice sharp cheddar cheese, some peach salsa prepared by a friend of ours and dipping mustard sauce that was provided by another friend.  Of course we needed a cold beer to facilitate passage down our gullets.  For dinner, we prepared chicken Alfredo.  The chicken was a couple of chicken thighs that we canned before we left home and the Alfredo sauce was a
An  osprey adorning a channel sign
packaged product made by Kerr. It made a really good combination. 

Our anchorage is behind a small island that stops the waves that roll off the Gulf.  The water here is quite shallow and it is entirely possible that we will be touching the bottom during the night when the tide goes out.  Our boat is designed to travel in really shallow water.  We can pull the centerboard and the rudder up so that we only need 18 inches of water to remain
Lumber Key anchorage at sundown
afloat. 
 
We both tried to read after dinner but sleep kept creeping in, making it difficult.

Thursday, March 3, 2016

Boat back together and Last day with the kids



Day 10:  Wednesday, March 2.

Today is the departure date for Scott and his family.  Claire prepared scrambled eggs and bacon for our final meal together.  We gathered our belongings and got into the car for our last trip back to our truck.

Yesterday, I fretted a bit on how we would get the motor back onto the boat while at the marina.  The motor is way too heavy to carry onto the boat and then hang it on the motor mount. I talked to the marina boat storage foreman about using one of his huge fork lifts to lower the motor but although willing to do so, he advised me that they charged $75.00 to start the lift plus $100.00 hour of operation time. So, we opted out of that plan. We decided to take the boat back to the launch ramp where we started.  There, we could back the boat onto the ramp and hang it in the reverse fashion that we had done two days before.  I felt that Janine and I could handle that but Scott insisted on joining in the fun.

So, Janine drove the truck, Scott drove his rental car, and I drove the boat by water back to the launch ramp.  I had more confidence in the little dinghy motor this time and so I cranked it up and was able to get 4.5 mph over the glassy water. 

The hanging of the motor went off without a hitch and when I hit the starter, the motor fired up as designed.  (The electrical problem was obviously the corroded plug.)  Also, a strong stream of water shot forth from the water pump weep hole.  Problems solved.  While Janine stayed with the boat, Scott and I took the truck to the storage area where it will remain until our return from our adventure.

We said our goodbyes to Scott and shoved off down the canal on our way back to the marina.  Scott headed back to the time share.  At about the same place where the motor quit two days ago, I checked the spray from the pump and could not see any water squirting out.  I immediately shut down the motor again, called Scott and told him to head back to the ramp – we had more problems. 

I started the motor, turned the boat around and using a run the motor, shut it down, and coast technique, we made it back to the ramp where Scott waiting.  While I was motoring down the canal at a low speed, I did notice that there was a fine stream of water coming from the weep hole. This told me that the pump could be working but that a piece of the old impeller had partially plugged the fitting at the end of the water outlet. We raised the motor and Scott took a small drill bit and worked it into the orifice of the outlet and upon firing up the motor, again had a strong stream of water.  Again, a relief.

We again said farewell and made an uneventful trip back to the marina. The remainder of the afternoon was spent straitening up the boat and blowing up Damn Dink Two in preparation for our trip south tomorrow. 

In the middle of the afternoon, Scott, Claire and the boys stopped by for one last goodbye on their way to the airport. 

Earlier, I had bought a bag of ice so for our pre dinner appetizer we enjoyed a cold beer and kipper snacks on crackers.  For our main course this evening, we prepared beef and noodles and peas.

This has been fun week.  We also look forward to the next part of our adventure.

Putting the motor back into running condition



Day 9:  Tuesday, March 1

We opted to spend the night in the boat.  Since we could not park our truck at the time share, we needed to have someone drive us whenever we needed to go somewhere.  Also since the car had two child’s car seats in it, if we all wanted to travel, we needed to first get the truck the return to pick up the rest of the crew.  Since we now have the boat at the marina, we can park the truck there and I wanted to get an early start to the repair shop so it made since for us to stay in the boat.

All of that said, it also gave me my first opportunity to have my sausage gravy on toast breakfast so I was sure that it was to be a great day.

We easily found the repair facility and they immediately carried the motor into the shop and a talented mechanic began ferreting out the electrical problem.  He first took the cowling off the engine so that he could determine if damage had occurred when the engine overheated.  In order for him to apply power to the engine, he had to remove the plug that we use to power it while on the boat.  In doing that, he found that one of the two wires was corroded.  He then applied power to the engine and found that all electrical systems were functioning normally.  A RELIEF on my part.  It meant that the problem was either the corroded plug or a wiring problem between the boat battery and the motor connection.  He continued his thorough check up on the engine and concluded that the engine was in good shape and ready to go.  I purchased an additional water pump kit so that after I replaced the faulty one, I would still have a spare.  He also suggested that the pump cover could also be melted and if that were so, it would need to be replaced.  However, he did not have one in stock so all I could do was to hope for the best. 
   
On our way back to the marina, we stopped at a 5 Guys hamburger joint for one of their fine cheeseburgers and their overabundance of fries.

Back at the marina, I parked the truck and pulled the lower unit off of the motor.  The water pump impeller was indeed completely roached and the cover which was lined in stainless steel appeared to be serviceable.  There was a significant amount of rubber from the old impeller tightly stuck to the cover wall but I was able to scrape it completely clean.  I installed the new impeller and reassembled the lower unit and felt that the motor was again back to normal.

We relaxed for the remainder of the afternoon.  It was decided that there would be no more work on the boat unto tomorrow.  Claire’s parents stopped by and picked us up for the trip back to the time share where we swam with the grand-kids, romped (as much as old people can romp) on the white sand beach and enjoyed the sunset.  Scott grilled some brats and Claire prepared a delightful pasta dish.  It was a most enjoyable family meal.

We spent the night in the time share.